Honeywell IntelliPath Series Installation And Setup Manual page 32

LTE-I Installation and Setup Guide
PROMPTS
Keypad Address
18
(28)_
Supervision
19
(24 Hours)_
Cell Rollover Y/N
20
(N)_
Cell 24Hr Tst Y/N
21
(N)_
Old Alarm Time
22
10 Minutes_
OPTIONS
[01-30]
 IP & Cell or Cell Only:
 None
 30 Day
 24 Hours
IP :
only
 None
 30 Day
 24 Hours
 6 minutes
 3 minutes
 90 seconds
_ _ _ _ _ _ _
Additional options for CN
only.
 1 Hr
 3 Min
 90 seconds
 75 seconds
[Y], [N]
[Y], [N]
 10 Min
 15 Min
 30 Min
 1 Hr
 2 Hrs
 4 Hrs
 8 Hrs
 12 Hrs
 24 Hrs
This address must be programmed if using either the Remote
Access feature or Direct Wire downloading. Enter the appropriate
device address.
NOTES:
1. This address must also be programmed as an alpha keypad in the
control panel or an AUI (Advanced User Interface) type device, if a
full enhanced graphic interface to the system is desired and the
control panel supports it. DO NOT connect an actual keypad (or
any other device) assigned to this address.
2. This address must be unique from the "Device Address" entered
in Prompt 15, and cannot equal that device address plus 1 (one) if
using 2-4204 mode.
The AlarmNet network must hear at least one supervisory message
from the communicator during this supervision period; otherwise,
AlarmNet notifies the central station that a communication failure
has occurred. (If the supervision period is changed after
registration, you must re-register the communicator.)
Press the [space] key to scroll through choices.
UL: For IP + Cell set to 24 Hrs. For IP only set to 3 Min. For Cell
only set to 24 Hrs.
A loss of communications is treated as an Alarm condition.
ULC: Must be set to" CN UL Line Lvl 3" for ULC-S304 Active Level
3 or ULC-S559 Active Fire installations. All other commercial
applications must be set to "24 Hrs".
This prompt appears only if comm. path is set to IP & Cell.
If enabled, all messages (including AlarmNet network supervisory
messages) are sent over the cell network in the event of an Internet
failure.
If disabled, all messages (except AlarmNet network supervisory
messages) are sent automatically over the cell network in the event
of an Internet failure.
UL/ULC: Must be set to "Y" if 24 hours is selected in Prompt: 19:
Supervision. Must be set to "N" for ULC-S304 Active Level 3 or
ULC-S559 Active Fire installations where CN UL Line Lvl 3 is
selected.
IMPORTANT WARNING: If set to "Y", AND Prompt 19:
Supervision is set to occur less than every 24 hours, this can result
in data overage charges on your monthly bill.
This prompt appears only if comm. path is set to IP & Cell.
If enabled a message is sent every 24 hrs over cell to verify proper
operation. If it fails, a Periodic Comm Test Failure message will be
sent over Ethernet.
UL/ULC: Must be set to "Y".
Sets how long an undeliverable alarm is retried for delivery to the
central station. If the message is not validated, it is retried until the
old alarm time is reached or the message is validated.
Press the [space] key to scroll through choices.
UL/ULC: Must be set to 10 minutes.
28
DESCRIPTION