Crossover - Pioneer SC-LX904 Instruction Manual

„ Crossover
Change the settings of crossover frequencies.
Setting Item Default Value
Front Small
Center Small
Height 1 Small
Setting Details
Set according to the speakers to be used.
"Small": When not using floor standing front
speakers.
"Large": When using floor standing front speakers.
• If "Configuration" - "Subwoofer" is set to "No",
"Front" will be fixed to "Large" and the low
pitched range of the other channels will be output
from the front speakers. Refer to the instruction
manual of your speakers to make the setting.
Set according to the speakers to be used.
"Small": When a center speaker where the speaker
diameter is 16 cm or less is to be used.
"Large": When a center speaker where the speaker
diameter is larger than 16 cm is to be used.
• When "Front" is set to "Small", this is set to
"Small".
• If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
Set according to the speakers to be used.
"Small": When height 1 speakers where the
speaker diameter is 16 cm or less are to be used.
"Large": When height 1 speakers where the
speaker diameter is larger than 16 cm are to be
used.
• When "Front" is set to "Small", this is set to
"Small".
• If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
Contents Connections
≫
Setting Item Default Value
Height 2 Small
Surround Small
Surround Back Small

Crossover

80Hz
160
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
Set according to the speakers to be used.
"Small": When height 2 speakers where the
speaker diameter is 16 cm or less are to be used.
"Large": When height 2 speakers where the
speaker diameter is larger than 16 cm are to be
used.
• When "Front" is set to "Small", this is set to
"Small".
• If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
Set according to the speakers to be used.
"Small": When surround speakers where the
speaker diameter is 16 cm or less are to be used.
"Large": When surround speakers where the speaker
diameter is larger than 16 cm are to be used.
• When "Front" is set to "Small", this is set to "Small".
• If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
Set according to the speakers to be used.
"Small": When surround back speakers where the
speaker diameter is 16 cm or less are to be used.
"Large": When surround back speakers where the
speaker diameter is larger than 16 cm are to be used.
• When "Surround" is set to "Small", this is set to
"Small".
• If an item cannot be selected even though
connection is correct, check that the settings in
"Configuration" - "Speaker Channels" matches
the number of connected channels.
When there are speakers that have been set to
"Small", set the Hz under which you would like
other speakers to play bass, and also set Hz under
which you would like the LFE (low frequency effect)
to play the bass.
The value from "50Hz" to "200Hz" can be set.
≫