Pioneer SC-LX904 Instruction Manual page 158

Setting Item Default Value Setting Details
Height 1 Speaker Top Front Set the speaker type if height speakers are
connected to the HEIGHT 1 terminals. Select "Top
Middle", "Top Rear", "Rear High", "Dolby Speaker
(Front)", "Dolby Speaker (Surr)", "Dolby Speaker
(Back)", "Front High" or "Top Front" according to
the type and layout of the connected speakers.
• This setting cannot be selected under any of
• When two sets of height speakers are being
• "Dolby Speaker (Surr)" and "Dolby Speaker
• If an item cannot be selected even though
Contents
following conditions. Set the height speakers
type to "Height 2 Speaker".
– "Bi-Amp" is set to "Front"
– "Zone Speaker" is set to "Zone 2/Zone 3"
used, "Top Rear", "Rear High", "Dolby Speaker
(Surr)", and "Dolby Speaker (Back)" cannot be
selected.
(Back)" can only be selected when surround
speakers or surround back speakers are being
used, respectively. You can check speakers that
you are using on the figure displayed in "Speaker
Channels".
connection is correct, check that the settings
in "Speaker Channels" matches the number of
connected channels.
Connections
≫
Setting Item Default Value
Height 2 Speaker Top Rear
158
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
Set the speaker type if height speakers are
connected to the HEIGHT 2 terminals. Select
"Front High", "Top Front", "Top Middle", "Top
Rear", "Rear High", "Dolby Speaker (Front)",
"Dolby Speaker (Surr)" or "Dolby Speaker (Back)"
according to the type and layout of the connected
speakers. However, the options selectable for the
"Height 1 Speaker" the are as follows.
If "Height 1 Speaker" is set to "Front High": Select
from "Top Middle", "Top Rear", "Rear High", "Dolby
Speaker (Surr)" or "Dolby Speaker (Back)".
If "Height 1 Speaker" is set to "Top Front" or "Dolby
Speaker (Front)": Select from "Top Rear", "Rear
High", "Dolby Speaker (Surr)" or "Dolby Speaker
(Back)".
If "Height 1 Speaker" is set to "Top Middle": Fixed
to "Rear High".
• "Dolby Speaker (Surr)" and "Dolby Speaker
(Back)" can only be selected when surround
speakers or surround back speakers are being
used, respectively. You can check speakers that
you are using on the figure displayed in "Speaker
Channels".
• If an item cannot be selected even though
connection is correct, check that the settings
in "Speaker Channels" matches the number of
connected channels.
≫