Pioneer SC-LX904 Instruction Manual page 11

1. INPUT SELECTOR dial: Switch the input to be played.
2. STATUS button: Switches the information on the display. (
3. ZONE 2 ON/OFF button: Turns ZONE 2 ON/OFF. (
4. ZONE 3 ON/OFF button: Turns ZONE 3 ON/OFF. (
5. ZONE CONTROL button: Controls the multi-zone function. (
6. DIMMER button: You can switch the display off or adjust the brightness of the
display in three steps.
7. Display ( p12)
8. PERSONAL PRESET 1/2/3 buttons: Registers the current setting conditions
such as input selector, listening mode, etc. or call the registered settings.
( p127)
9. NETWORK indicator: This lights when "NET" is selected with the input
selector and the unit is connected to the network. Lights up when any of the
following functions is working or enabled in standby state of this unit. When
this indicator is lighting, the power consumption in standby state increases,
however, the increase in power consumption is minimized by entering the
HYBRID STANDBY mode where only the essential circuits operate. It does not
light when ZONE 2/ZONE 3 is on, however.
– HDMI CEC ( p167)
– HDMI Standby Through ( p167)
– USB Power Out at Standby (
p169)
– Network Standby (
– Bluetooth Wakeup ( p169)
10. Remote control sensor: Receives signals from the remote controller.
• The signal range of the remote controller is within about 16´/5 m, at an
angle of 20° on the perpendicular axis and 30° to either side.
11. MCACC PRO indicator: This lights when you have enabled the speaker
calibration made with MCACC. (
12. MASTER VOLUME
13. STANDBY/ON button: When the power is turned on, the periphery of the
button lights up. This lights dimly when you have pressed number 7 DIMMER
repeatedly to turn the display off.
14. AV ADJUST button: Settings such as "HDMI" and "Audio" can be made quickly
during play on the TV screen. (
15. HOME button: Displays the Home. (
16. Cursor buttons ( / / / ) and ENTER button: Select the item with the
cursors and press ENTER to confirm. Use them to tune to stations when using
p135)
p123)
p125)
p122)
p169)
p180, 203)
p198)
p151, 179, 194)
Contents Connections
≫
TUNER. ( p117)
17. RETURN button: Returns the display to the previous state.
18. TUNING MODE button: Switches the tuning mode. (
19. PHONES jack: Headphones with a standard plug (ø1/4"/6.3 mm) are
connected.
20. SETUP MIC jack: The supplied speaker setup microphone is connected.
( p180, 203)
21. Listening mode button: Switches the listening mode. (
22. USB port: A USB storage device is connected so that music files stored in it
can be played. (
23. AUX INPUT HDMI jack: Connect a video camera, etc. using an HDMI cable.
( p83)
24. Front flap
11
Front
Playback
≫
p103)
Panel≫ Rear Panel≫ Remote≫
Setup
≫ ≫
p117)
p133)