Pioneer SC-LX904 Instruction Manual page 188

Setting Item Default Value Setting Details
Surr Back Left 0.0 dB After selecting the speaker frequency from between
"63 Hz" and "16 kHz" with the cursors
the volume of that frequency between "–12.0 dB"
and "+12.0 dB" (in 0.5 dB intervals) with
readjust the overall volume balance with "Trim",
select "Trim" in
volume.
• If "OVER!" is displayed during adjustment,
• "63 Hz" can only be selected when this speaker
• If an item cannot be selected even though
Contents
/ , adjust
/ , and use / to adjust the
the volume of the frequency band or another
frequency band is too high, so reduce the
volume of the frequency bands until the display
disappears.
is set to "Large" in "System Setup" - "Speaker" -
"Crossover".
connection is correct, check that the settings in
"System Setup" - "Speaker" - "Configuration"
- "Speaker Channels" matches the number of
connected channels.
Connections
≫
Setting Item Default Value
Surround Left 0.0 dB
/ . To
Subwoofer 1 0.0 dB
188
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
After selecting the speaker frequency from between
"63 Hz" and "16 kHz" with the cursors
the volume of that frequency between "–12.0 dB"
and "+12.0 dB" (in 0.5 dB intervals) with
readjust the overall volume balance with "Trim",
select "Trim" in / , and use / to adjust the
volume.
• If "OVER!" is displayed during adjustment,
the volume of the frequency band or another
frequency band is too high, so reduce the
volume of the frequency bands until the display
disappears.
• "63 Hz" can only be selected when this speaker
is set to "Large" in "System Setup" - "Speaker" -
"Crossover".
• If an item cannot be selected even though
connection is correct, check that the settings in
"System Setup" - "Speaker" - "Configuration"
- "Speaker Channels" matches the number of
connected channels.
After selecting the speaker frequency from between
"31 Hz" and "250 Hz" with the cursors
the volume of that frequency between "-12.0 dB"
and "+12.0 dB" (0.5dB intervals) with
readjust the overall volume balance with "Trim",
select "Trim" in / , and use / to adjust the
volume.
• If "OVER!" is displayed during adjustment,
the volume of the frequency band or another
frequency band is too high, so reduce the
volume of the frequency bands until the display
disappears.
• This cannot be selected if "No" is set in
"System Setup" - "Speaker" - "Configuration" -
"Subwoofer".
≫
/ , adjust
/ . To
/ , adjust
/ . To