Display - Pioneer SC-LX904 Instruction Manual

Display

1. Cursor ( / / / ): This may light when performing operations with the
"NET", "USB" input selector.
2. Lights in the following conditions.
Z2/Z3: ZONE 2/ZONE 3 is on.
: Connected by BLUETOOTH.
: Connected by Wi-Fi.
NET: Lights when connected to the network with the "NET" input selector. It
will blink if incorrectly connected to the network.
USB: Lights when the "USB" input selector is selected, a USB device is
connected and the USB input is selected. It will blink if the USB device is not
properly connected.
HDMI: HDMI signals are input and the HDMI input is selected.
DIGITAL: Digital signals are input and the digital input is selected.
3. Lights according to the type of input digital audio signal and the listening
mode.
4. Lights in the following conditions.
RDS (European models): Receiving RDS broadcasting.
TUNED: Receiving AM/FM radio.
STEREO: Receiving FM stereo.
SLEEP: Sleep timer is set. ( p168)
AUTO STBY: Auto Standby is set. (
5. Displays the audio output destination.
Contents
p168)
Connections
≫
SP A: Outputs audio only to SPEAKER A.
SP B: Outputs audio only to SPEAKER B.
SP AB: Outputs audio to both SPEAKER A and SPEAKER B.
A: Outputs audio only to ZONE A.
B: Outputs audio only to ZONE B.
AB: Outputs audio to both ZONE A and ZONE B.
6. Lights when headphones are connected.
7. Blinks when muting is on.
8. Displays various information of the input signals.
9. Lights when adjusting the volume.
10. Speaker/Channel display: Displays the output channel that corresponds to the
selected listening mode.
12
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫ ≫