Eq Adjust - Pioneer SC-LX904 Instruction Manual

Setting Item Default Value
Subwoofer 0.0dB
„ EQ Adjust
If you perform Full Auto MCACC then settings are automatic, but you can also
adjust the output volume of the range of each connected speaker to suit your own
preferences. You can adjust the volume of the different sound ranges for each of
the speakers. You can select up to 4 bands for the Subwoofer and 9 bands for all
other speakers. If the overall volume balance changes by adjusting the volume of
each frequency, you can readjust the balance in "Trim".
Setting Item Default Value
Front Left 0.0 dB
Setting Details
Control the effect of standing waves for the
subwoofer.
1. After selecting "Filter" with / , select the filter
to be adjusted from "1" to "3" with /
press ENTER.
2. After selecting the central frequency with
adjust the bandwidth with / , then adjust
the attenuation with / . The central frequency
can be selected between "63Hz" and "250Hz".
The bandwidth can be selected between "2.0"
and "9.8" (0.2 intervals). Attenuation can be
selected between "0.0dB" and "12.0dB" (0.5dB
intervals).
Setting Details
After selecting the speaker frequency from between
"63 Hz" and "16 kHz" with the cursors
the volume of that frequency between "–12.0 dB"
and "+12.0 dB" (in 0.5 dB intervals) with
readjust the overall volume balance with "Trim",
select "Trim" in / , and use / to adjust the
volume.
• If "OVER!" is displayed during adjustment,
the volume of the frequency band or another
frequency band is too high, so reduce the
volume of the frequency bands until the display
disappears.
• "63 Hz" can only be selected when this speaker
is set to "Large" in "System Setup" - "Speaker" -
"Crossover".
Contents Connections
≫
Setting Item Default Value
Center 0.0 dB
and
/ ,
Front Right 0.0 dB
/ , adjust
/ . To
184
Playback
≫
Setting Details
After selecting the speaker frequency from between
"63 Hz" and "16 kHz" with the cursors
the volume of that frequency between "–12.0 dB"
and "+12.0 dB" (in 0.5 dB intervals) with
readjust the overall volume balance with "Trim",
select "Trim" in / , and use
volume.
• If "OVER!" is displayed during adjustment,
the volume of the frequency band or another
frequency band is too high, so reduce the
volume of the frequency bands until the display
disappears.
• "63 Hz" can only be selected when this speaker
is set to "Large" in "System Setup" - "Speaker" -
"Crossover".
• If an item cannot be selected even though
connection is correct, check that the settings in
"System Setup" - "Speaker" - "Configuration"
- "Speaker Channels" matches the number of
connected channels.
After selecting the speaker frequency from between
"63 Hz" and "16 kHz" with the cursors
the volume of that frequency between "–12.0 dB"
and "+12.0 dB" (in 0.5 dB intervals) with
readjust the overall volume balance with "Trim",
select "Trim" in / , and use
volume.
• If "OVER!" is displayed during adjustment,
the volume of the frequency band or another
frequency band is too high, so reduce the
volume of the frequency bands until the display
disappears.
• "63 Hz" can only be selected when this speaker
is set to "Large" in "System Setup" - "Speaker" -
"Crossover".
Front Panel≫ Rear Panel≫ Remote≫
Setup
≫ ≫
/ , adjust
/ . To
/ to adjust the
/ , adjust
/ . To
/ to adjust the