Table of Contents
Advertisement
Figure 2-7
Rack Mounting the I-Series Switch
1 19-inch rack
Attaching the External Power Supply to the Rack Mount Bracket
The I3H-PWR power supply can be attached to the right or left rack mount bracket in either a high
or low position, using the small section of DIN rail, two panhead Phillips screws, and two nuts
with lock washers that are shipped with the mounting kit.
To attach the I3H-PWR power supply:
1.
Using two panhead screws and lock washers, attach the small section of DIN rail to one of the
brackets, as shown in
mounted in the low position. To attach in the high position, use the two screw holes at the top
of the bracket face.
2.
Holding the power supply as shown in
the power supply over the top of the DIN rail section.
3.
Push down on the half circle tab at the top of the power supply and rotate the power supply
down and forward until the bottoms of the power supply clips hook over the bottom edge of
the DIN rail section.
4.
Release the half circle tab at the top of the power supply.
The power supply should be firmly attached to the DIN rail section.
5.
Refer to the documentation shipped with the power supply for wiring information.
2 Mounting screws
Figure 2-8
on page 2-14.
Figure 2-9
Figure 2-8
shows the DIN rail section being
on page 2-14, hook the tops of the clips on
Enterasys I-Series Hardware Installation Guide 2-13
Mounting the Switch
Advertisement
Chapters
Table of Contents
