Configuring The Mk8000; Configuration Checklist - Siemens MK8000 MP4.30 Installation/Configuration Manual

Configuring the MK8000

4 Configuring the MK8000
4.1

Configuration Checklist





46
Building Technologies
Fire Safety & Security Products
DMS Configuration Process Overview
The following two checklists tell you what you need for MK8000 configuration, and
the steps you go through to configure it. Make a mark in the corresponding check-
box as you satisfy each item. The configuration checklist is a general guide to the
larger configuration process. The order in which you perform the tasks in the
checklist may vary depending on your personal preference. This is not an absolute
guide, but rather lends context to the tasks discussed in this manual.
Note: A similar configuration list is provided in the DMS8000 connectivity configu-
ration guide. While the two lists are similar, they are not identical, as each product
has specific characteristics that impact this process. The list in the Connectivity
Guide serves as an overview of DMS product configuration in general, while the list
provided below is a list of the actual steps in the MK8000 configuration process.
The following abbreviations are used this table:
 DMS-CG – DMS8000 connectivity Configuration Guides:
 Network and Subsystem Connectivity (document no. A6V10062425)
 Video Connectivity (document no. A6V10062457)
 SiPass Connectivity (document no. A6V10062451).
 DMS – Danger Management System
 SPECS – Configuration specifications (agreed upon with the customer).
 N/A – Not Applicable – this step, while included in the list of configuration steps
for DMS products (for example, in the connectivity guide) is not necessary for
this product.
ITEMS NEEDED FOR CONFIGURATION
Administrator logon id and password
Networked OPC Server (Stand-Alone station) and FEPs with software installed
Composer installed on the server machine
Station names and IP addresses of OPC Server (Stand-Alone station) and FEP
PCs
048_DMS_MK8000_ICC_MP4.30_A6V10062407_a_en
06.2010