Siemens MK8000 MP4.30 Installation/Configuration Manual page 37

Building Technologies
Fire Safety & Security Products
Fig. 35 Selecting the Automatic Server Startup
In the same window, you can set the dual server option and set specify the
PC names of the physical machines supporting the Marathon EverRun FT
environment. Note that the IP address is not valid.
 Refer to 3.2.1.1 at pag.16.
4f. Server PC name
If installing a Test Client or FEP station, enter the network name of the
server (Stand-Alone) station. Note that the IP address is not valid.
The installation procedure starts: files are copied on the hard disk.
4g. Hardware key
If prompted by the procedure, temporarily remove the hardware key from the
parallel or USB port of your PC. You can insert it again after the software in-
stallation.
Fig. 36 If already installed, temporarily remove the hardware key
4h. When prompted, reboot
When the PC starts up again, logon in Windows using the same username
as in step 1 above.
4i. Registering services and installing Plug-ins
Now, the setup registers the MK8000 service tasks in Windows and installs
the Composer tools. This may take a minute.
4j. Initialising databases
The MS-SQL databases for supporting the MK8000 projects need now to be
initialised. This may take some minutes.
4k. Setup complete
The setup procedure is now complete, the following window appears:
048_DMS_MK8000_ICC_MP4.30_A6V10062407_a_en
Installation
37
06.2010