Table of Contents
Advertisement
Chapter 3
Device Management
Figure 9: Serial DB9 Console Port
a
Connected internally.
b
Connected internally.
Ethernet Ports
Connect any of the available Ethernet ports on the device to a management switch and access the RUGGEDCOM
ROS console and Web interfaces via the device's IP address. The factory default IP address for the RUGGEDCOM
RS920W is https://192.168.0.1.
For more information about available ports, refer to
Section 3.2
Configuring the Device
Once the device is installed and connected to the network, it must be configured. All configuration management
is done via the RUGGEDCOM ROS interface. For more information about configuring the device, refer to the
RUGGEDCOM ROS User Guide associated with the installed software release.
16
1
5
9
6
Pin
a
1
2
3
a
4
5
a
6
b
7
b
8
9
Chapter 4, Communication
RUGGEDCOM RS920W
Installation Guide
Name
Description
Reserved (Do Not Connect)
TX
Transmit Data
RX
Receive Data
Reserved (Do Not Connect)
GND
Signal Ground
Reserved (Do Not Connect)
Reserved (Do Not Connect)
Reserved (Do Not Connect)
Reserved (Do Not Connect)
Ports.
Configuring the Device
Advertisement
Table of Contents
