Configuring The Web Server - Siemens SIMATIC S7-1500 Function Manual

2.2

Configuring the Web server

Requirements
You have opened the properties dialog of the CPU in the STEP 7 project view.
Procedure
Figure 2-1
To use the full range of functions offered by the Web server, you need to make the following
listed settings in STEP 7:
● ① Activating the Web server
Web server
Function Manual, 01/2013, A5E03484625-01
Web server settings in STEP 7
The Web server is disabled in the basic setting of a configured CPU; to enable the Web
server, follow these steps:
– Open the "Devices & Networks" view with a double-click in the STEP 7 project tree.
– Select the required CPU in the device view, network view or topology view.
– Navigate to the "Web server" area in the Inspector window properties, "General" tab.
– Select the "Enable Web server on this module" check box.
The following notice is output:
Figure 2-2 Security notice upon activation of the Web server in STEP 7
General information
2.2 Configuring the Web server
11