Advertisement
Turning on the Device
Turn device on via the POWER switch located at the base of the device (Fig.1).
Note: Each time the device is powered up, the extension, flexion, speed and pause
settings will be the same as when the device was last run. The SET-Lock Switch
(next to the base power switch) should be in the SET position to make settings.
Start/Stop Control Button
You may stop and restart the CPM at any time by depressing the START/STOP
button on the Motion Controller. The device will proceed in the opposite direction
upon restarting.
Danger!
Adjust Motion Settings only under physician's or Therapist's orders.
Warm-Up Feature
Turn on the device from the POWER Switch located at the base of the device.
In the motion controller display window you will be prompted with a choice of
whether to initiate the WARM UP feature or not. You must choose Y (yes) or N
(no) to proceed.
Selecting the Warm Up Feature:
Choose Y (yes) by pressing the EXT button on the Motion Controller.
By-Passing the Warm Up Feature:
Choose N (no) by pressing the FLEX button on the Motion Controller.
De-selecting the Warm Up Feature:
To turn off the Warm Up feature, turn the device off then on again at the POWER
Switch. Select N (no) to exit the Warm Up feature prompt.
Setting Range of Motion (ROM) Parameters
The 480 achieves a maximum ROM of -5° extension to 110° flexion.
The 520 achieves a maximum ROM of -10° extension to 125° flexion.
The ROM settings are continuously displayed in the Motion Controller.
To set the ROM parameters, press and hold the EXT or the FLEX button while
simultaneously depressing the desired Up arrow or Down arrow buttons (Fig.2).
The Extension and Flexion angles will change slowly for the initial 5 degrees to
allow for precise adjustment); following this, the parameters will change rapidly to
allow for quicker adjustment.
Advertisement
