the accessory box to screw the rubber onto the hard disk.
The finished hard disk assembly is shown in Figure 2-8.
2. Turn off the PPC-103 and remove the rear cover.
3. Connect the HDD flat cable (44-pin to 44-pin) from the
hard disk to the PC board, as shown in Figure 2-9. Make
sure that the red wire corresponds to pin 1 on the connector,
which is labeled on the board. Plug the other end of the
cable into the enhanced IDE hard disk, with pin 1 on the
cable corresponding to pin 1 on the hard disk. The HDD flat
2 2
PPC-103 User's Manual
Figure 2-8: Rubber screwed onto the hard disk