Wall-Mounting (Optional); Figure 1-7: Ppc-103 Wall Mounting Configuration - Advantech PPC-103 Manual

1.7.3 Wall-mounting (optional)

An optional wall-mounting attachment is also available for mounting the
PPC at approximately 45° to a flat surface. Installation instructions
follow:
1. The wall-mounting attachment is comprised of three parts: one back
bracket, one support bracket, and one mounting bracket.
2. First attach the back bracket to the rear cover of the PPC-103,
securing it in place with four of the philips-head screws provided.
3. Using a flat-head screwdriver, attach the support bracket to the back
bracket using four of the flat-head screws provided, two on either
side of the support bracket. The sides of the support bracket should
overlap the sides of the back bracket, and the screws should secure
one bracket to the other through the existing holes drilled into each
bracket.
4. Mount the mounting bracket on the wall or other flat surface. The
support bracket slides vertically from the top into the mounting
bracket. It can then can be secured to the mounting bracket by
screwing one of the philips-head screws provided through the
corresponding holes at the tops of the mounting bracket and the
support bracket.

Figure 1-7: PPC-103 wall mounting configuration

Chapter 1 General Information 1 1