Installing The 2.5" Hard Disk Drive (Hdd); Figure 3-2: Installing The Primary 2.5" Hdd - Advantech POC-174 User Manual

3.3 Installing the 2.5" Hard Disk Drive (HDD)

You can attach one enhanced Integrated Device Electronics (IDE) hard
disk drive to the Point of Care Terminal's internal controller which uses
a PCI local-bus interface. The advanced IDE controller supports faster
data transfer and allows the IDE hard drive to exceed 60 GB. The
following are instructions for installation:
1. Detach and remove the plastic rear cover and side panel.
2. There is a metal plate which holds the HDD to the upper right-hand
side of the metal shielding case. (See Fig. 3-2.) Remove the two
screws on the metal plate.
3. Pull the metal plate toward the outside of the unit, and remove it
from the two lugs of the shielding case.
4. Place the HDD on the metal plate, and tighten the four screws from
the bottom of the metal plate.
5. The HDD cable (1 x 44-pin to 1 x 44-pin) is next to the metal plate.
Connect the HDD cable to the HDD. The other end of the HDD
cable is connected to the PC board (CN16). Make sure that the
red/blue wire corresponds to Pin 1 on the connector, which is
labeled on the board. Plug the other end of the cable into the IDE
hard drive, with Pin 1 on the cable corresponding to Pin 1 on the
hard drive.
28 POC-174 User's Manual

Figure 3-2: Installing the primary 2.5" HDD