Honda Hawk GT NT650 1988 Service Manual page 220

Tester:
07411-0020000
KS-AHM-32-003
07308-0020001
TH-5H
(KOWA Digital type)
(KOWA Digital type; U.S.A. only)
(SANWA Analogue type)
(KOWA Analogue type)
BATTERY/CHARGING SYSTEM
Tester
Range
SANWA kO
KOWA
RX100
ITEM TERMINALS STANDARDS
Battery charging line Red/White
(+)
and Green (-) Battery voltage should come
Alternator coil line Yellow and Yellow 0.1-1.00 (20°C/68°F)
Check the resistances between the leads with an ohmmeter. If
the resistance is out of the specifications, make a UNIT IN-
SPECTION indicated below.
UNIT INSPECTION
Unit: k{l
Provided the circuit on the wire harness side are normal and
there are no loose connections at the connector, inspect the
regulator/rectifier unit by measuring the resistance between
the termi.nals.
NOTE
You'll get false readings if the probes touch your fingers.
Use the specified multitesters. Using other equipment may
not allow you to obtain the correct results.
This is due to the characteristic of semiconductors, which
have different resistance values depending on the applied
voltage.
SPECIFIC
MUL
TITESTER:
- 07411-0020000 (KOWA Digital type)
- KS-AHM-32-003 (KOWA Digital type; U.S.A. only)
- 07308-0020001 (SANWA Analogue type)
- TH-5H (KOWA Analogue type)
Select the following range:
SANWA: kO
KOWA: X100
• An old battery stored in the multitester could cause inaccu-
rate readings. Check the battery if the multitester resis-
tance incorrectly.
• When using the KOWA multitester, remember that all read-
ings should be multiplied by 100.
Replace the regulator/rectifier unit if the resistance value be-
tween the terminals is abnormal.
I'"
EB
Probe
Red/ Yellow Yellow Yellow
Green
8
Probe ' "
White 1 2 3
Red/White
---------
20-100 20-100 20-100 10-50
Yellow 1
0.5-10
~
30-500 30-500 20-200
Yellow 2 0.5-10 30-500
~
30-500 20-200
Yellow 3 0.5-10 30-500 30-500
~
20-200
Green
1-20 0.5-10 0.5-10 0.5-10
---------
Manufacture Range
SANWA kO
KOWA RX100
15-9