Honda Hawk GT NT650 1988 Service Manual page 177

REAR WHEEL/SUSPENSION
Apply clean grease to the dust seal lip.
Install the bearing stop ring and dust seal securely.
NOTE
• Install the bearing with sealed end facing out.
Carefully press the new ball bearings in with the special tools.
(3) ATTACHMENT/PILOT
(2) ECCENTRIC
BEARING CARRIER
07749-0010000
07746-0010500
TOOLS:
Driver
Attachment 62 x 68 mm
Apply clean grease to the dust seal lip.
Install the bearing stop ring and dust seal securely.
,
.
Driven flange
Separate the cover and the flange.
Remove the dampers and the a-ring.
()8i~3)
DAMPER
~
(4) O-RING
(2) FLANGE
13-10