Honda Hawk GT NT650 1988 Service Manual page 172

INSTALLATION






L--
_
Do not service the rear wheel (removal/installation) while ex-
haust system is hot.
CAUTION
Cover the left rim edge, spindle edge and brake caliper with
tape to avoid damaging the wheel.
Use care not to damage the wheel rim and brake disc when re-
moving the wheel.
Install the rear wheel in the reverse order of removal.
Clean the wheel and spindle mating surface.
Align the index marks and install the wheel hub over the drive
pins.
Insert the axle in the wheel hub, making sure the splines are
correctly aligned.
Tap the axle with soft hammer to seat the axle securely.
Turn the eccentric bearing carrier counterclockwise until it
stops.
Install the drive chain onto the rear sprocket.
Clean and apply clean grease to the axle threads.
CAUTION
• Make sure that the axle threads are applied clean grease to
obtain the specified torque.
Install the axle center collar, shim and wheel nut.
Tighten the wheel nut to the specified torque.
TORQUE: 120 N'm (12.0 kg-m, 87 ft-Ibl
Install a new cotter pin and cap securely.
Apply the rear brake several times and check for free wheel ro-
tation when released.
Adjust the drive chain slack (page 3-12).
REAR WHEEL/SUSPENSION
(1) INDEX MARKS
3) DRIVE
CHAIN
,A'\~
i I
fh-'l/lit
1/
(1) AXLE CENTER COLLAR
----
-
\
""
/,
13-5