Honda Hawk GT NT650 1988 Service Manual page 210

HYDRAULIC BRAKE
Remove the cotter pin and joint pin, and disconnect the brake
actuating arm from the master cylinder push rod.
Remove the following:
- brake pedal return spring
- brake light switch spring
- snap ring
- brake pedal
Apply clean grease to the brake pedal pivot and install the
pedal into the bracket with the snap ring.
Installation is the reverse order of removal.
Install the right foot peg bracket. Tighten the mounting bolts.
TORQUE: 22 N'm (2.2 kg-m. 16 ft-Ibl
Install the muffler mounting bolt and nut.
TORQUE: 27 N'm (2.7 kg-m. 20 ft-Ibl
14-18