Lubrication - Honda Hawk GT NT650 1988 Service Manual

2. LUBRICATION
SERVICE INFORMATION
TROUBLESHOOTING
ENGINE OIL LEVEL
ENGINE OIL CHANGE
OIL FILTER CHANGE
2-1
2-2
2-3
2-3
2-4
OIL PRESSURE CHECK
OIL PUMP/RELIEF VALVE
CONTROL CABLE LUBRICATION
LUBRICATION POINTS
2-4
2-5
2-10
2-10
SERVICE INFORMATION
_l-- _
If the engine must be running to do some work, make sure the area is well-ventilated. Never run the engine in an enclosed area.
The exhaust contains poisonous carbon monoxide gas that may cause loss of consciousness and lead to death.
CAUTION
Used engine oil may cause skin cancer
if
repeatedly left in contact with the skin for prolonged periods. Although this
is
unlikely
unless you handle used oil on a daily basis, it
is
still advisable to thoroughly wash your hands with soap and water as soon as possi-
ble after handling used oil.
GENERAL
• The oil pump can be serviced after removing the engine from the frame.
SPECIFICATIONS
Engine oil
Oil capacity 2.8 lit (2.94 US qt, 2.46 Imp qt) after disassembly.
2.3 lit (2.43 US qt, 2.02 Imp qt) at oil filter and oil change.
2.2 lit (2.32 US qt, 1.94 Imp qt) after draining.
Oil recommendation HONDA 4 stroke oil or equivalent API
service classification: SE or SF
VISCOSITY: SAE 10W-40
Other viscosities shown in the chart may
be used when the average temperature
in your riding area is within the indicated
range.
OIL VISCOSITIES
Oil pump
-20 -10 0 10
20 30 40'C
ITEM STANDARD SERVICE LIMIT
Rotor tip clearance 0.15 mm (0.006 in) 0.20 mm (0.008 in)
Pump body clearance 0.15-0.22 mm (0.006-0.009 in)
0.35 mm (0.014 in)
Pump end clearance 0.02-0.07 mm (0.001 -0.003 in)
0.10 mm (0.004 in)
Oil pressure 441 kPa (4.5 kg/cm 2 , 64 psi) at 6,000 rpm (80oC/176°F)
- -
TORQUE VALUES
Oil pressure switch
Engine oil drain bolt
Oil filter
12 N'm (1.2 kg-m, 9 ft-Ib) Apply sealant to the threads
35 N'm (3.5 kg-m, 25 ft-Ib)
10 N'm (1.0 kg-m, 7.2 ft-Ib)
2-1