Headlight - Honda Hawk GT NT650 1988 Service Manual

HEADLIGHT
REMOVAL/INSTALLATION
Remove the two screws and headlight.
Disconnect the headlight connector and remove the rubber
protector.
LIGHTS/METERS/SWITCHES
(1) HEADLIGHT CONNECTOR
~"~\.
Remove the headlight retainer clip and replace the headlight
bulb.
CAUTION
This motorcycle
is
equipped with a halogen headlight bulb.
Do not put finger prints on the headlight bulb, they may create
hot spots on the hulb.
If you touch the bulb with your bare hands, clean it with a cloth
moistened with alcohol to prevent its early failure.
Do not try to replace the bulb or clean the headlight with the
light ON.
After replacing the bulb, instal/the rubber boot tightly against
the unit.
(1) RETAINE
NOTE
• Install the rubber protector with the top mark facing up.
Install the headlight in the reverse order of removal.
(1) "TOP" MARK
~"
L------'-\.
/
\p
(2) RUBBER PROTECTOR
18-3