Table of Contents
Advertisement
NAMES OF MACHINE PARTS
NAMES OF MACHINE PARTS
■ Main Parts
a
1 Top cover
2 Pretension disk (page 24)
3 Thread guide for bobbin winding (page 24)
4 Spool pin (page 25)
5 Spool cap (page 23)
6 Supplemental spool pin (page 23)
7 Bobbin winder (page 23)
8 LCD (liquid crystal display) (page 15)
9 Speaker
0 Operation buttons (page 10)
A Embroidery unit (page 35)
B Thread cutter (page 29)
C Thread guide plate (page 25)
D Connector for the presser foot (page 108)
E Handle
Carry the machine by its handle when transporting the
machine.
F Presser foot lever
You cannot use the presser foot lever after the presser foot has
been raised using
G Air vent
The air vent allows the air surrounding the motor to circulate.
Do not cover the air vent while the machine is being used.
H Main power switch (page 14)
I Power cord receptacle (page 14)
J USB port for mouse (page 23)
K USB port
L Handwheel
Turn the handwheel toward you (counterclockwise) to raise and
lower the needle.
10
(Presser foot lifter button).
■ Needle and Presser Foot Section
a
1 Screw for embroidery foot (page 108)
2 Embroidery foot
The embroidery foot helps control fabric flexibility for better
stitch consistency.
3 Bobbin cover (page 26)
4 Needle plate cover (page 27)
5 Needle plate (page 107)
6 Needle bar thread guide (page 29)
7 Needle clamp screw (page 31)
■ Operation Buttons
1 "Start/Stop" button
Press the "Start/Stop" button to start or stop the machine. The
button changes color according to the machine's operation
mode.
Green:
The machine is ready to embroider or is
embroidering.
Red:
The machine is not ready to start
embroidering.
2 Needle position button
Press the needle position button to raise or lower the needle
position. Pressing the button twice embroiders a single stitch.
3 Thread cutter button
Press the thread cutter button after embroidering to trim the
excess thread.
4 Presser foot lifter button
Press the presser foot lifter button to lower the presser foot and
apply pressure to the fabric. Press this button again to raise the
presser foot.
5 Automatic threading button
Use the automatic threading button to automatically thread the
needle.
Advertisement
Table of Contents
