Download  Print this page

Cleaning The Cutter In The Bobbin Case Area; Changing Embroidery Foot "w+" With Led Pointer - Brother 882-W80 Operation Manual

Hide thumbs

Advertisement

*
Make sure that the indicated points are aligned
before installing the bobbin case.
CAUTION
• Never use a bobbin case that is scratched,
otherwise the upper thread may become
tangled, the needle may break or machine
performance may suffer. For a new bobbin
case, contact your nearest Brother authorized
service center.
• Be sure that the bobbin case is correctly
installed, otherwise the needle may break.
i
Insert the tabs on the needle plate cover into the
needle plate, and then slide the cover back on.
j
Reattach the bobbin cover.

Cleaning the Cutter in the Bobbin Case Area

The cutter below the needle plate should be cleaned. If
dust or lint accumulate on the cutter, it will be difficult
to cut the thread when
pressed or the automatic thread cutting function is used.
Clean the cutter when the thread is not easily cut.
a
a
Follow steps
through
remove the needle plate cover.
b
Use the screwdriver included with the machine to
unscrew and remove the needle plate.
c
Use the cleaning brush or a vacuum cleaner to remove
any lint and dust from the cutter in the bobbin case
area.
1 Cutter
(Thread cutter button) is
e
in "Cleaning the Race" to
a
CARE AND MAINTENANCE
CAUTION
• Do not touch the cutter, otherwise injuries
may result.
d
Align the two screw holes in the needle plate with the
two holes at the needle plate mounting base, and then
fit the needle plate onto the machine.
e
Lightly finger-tighten the screw on the right side of the
needle plate. Then, use the screwdriver included to
firmly tighten the screw on the left side. Finally, firmly
tighten the screw on the right side.
f
Replace the bobbin case and the needle plate cover
h
following steps
through
Changing Embroidery Foot "W+" with LED
Pointer
CAUTION
• When attaching an embroidery foot, always
press
on the screen. You may
accidentally press the "Start/Stop" button and
possibly cause injury.
• Be sure to use embroidery foot "W+" with LED
pointer when doing embroidery. Using
another embroidery foot may cause the needle
to strike the embroidery foot, causing the
needle to bend or break and possibly cause
injury.
a
Press
(Needle position button) to raise the needle.
b
Press
to lock all keys and buttons.
*
If the message [OK to automatically lower the
presser foot?] appears on the LCD screen, press
to continue.
Note
• Before replacing the needle, cover the hole in the
needle plate with fabric or paper to prevent the
needle from falling into the machine.
j
in "Cleaning the Race".
107
5

Advertisement

Table of Contents

   Related Manuals for Brother 882-W80

This manual is also suitable for:

882-w82

Comments to this Manuals

Symbols: 0
Latest comments: