Brother 882-W80 Operation Manual page 37

■ Attaching the Embroidery Unit
a
Turn the main power to OFF.
b
Insert the embroidery unit connection into the
machine connection port. Push lightly on the
connection port cover until the unit clicks into place.
1 Embroidery unit connection
2 Machine connection port
3 Carriage
Note
• Be sure there is no gap between the embroidery
unit and the machine. If there is a gap, the
embroidery patterns will not embroider with the
correct registration.
c
Turn the main power to ON.
 The following message will appear.
d
Press .
 The carriage will move to the initialization position.
a
c
■ Removing the Embroidery Unit
a
Press , then press
 The carriage will move to the removal position.
CAUTION
• Always remove the embroidery frame before
pressing . Otherwise, the frame may strike
the embroidery foot, and possibly cause injury.
b
Turn the main power to OFF.
c
Squeeze the release lever, and pull the embroidery unit
away from the machine.
BEFORE EMBROIDERING
.
2
35