Replacement Procedure
Touch Screen Control Board Replacement
Touch Screen Control Board Replacement
Tools Required
•
•
•
Removal Procedure
Refer to
Step 1. Remove the Outer Cover as described in
page
Step 2. Remove the Front Panel as described in
page
Step 3. Remove the two TORX T8 screws (item 1) fastening the Touch Screen Control
Board for the front panel rear side.
Step 4. Disconnect the flat cable connector (item 2) from the A52 Front Panel
Interface Board.
Step 5. Disconnect the flat cable connector (item 3) from the LCD Assembly.
Replacement Procedure
Step 1. Reverse the order of the removal procedure.
Set a torque to 5 in-lb for torque driver when fasten the TORX T8 screws
(item 1).
Figure 4-19
Touch Screen Control Board Removal
Keysight E5061B Network Analyzers
torque screwdriver, T15 and T20
torque screwdriver, T8 (set to 5 in-lb)
flat edge screwdriver
Figure 4-19
for this procedure.
55.
56.
"Outer Cover Replacement" on
"Front Panel Replacement" on
89