Fanvil i10 User Manual page 56

Output Settings
Output Response
Triggered by DTMF
Ring tone
Triggered by URI
Ringtone
Triggered By SMS
Ringtone
Triggered By Dsskey
Ringtone
Standard Status
Output Duration
Trigger by DTMF
DTMF Trigger Code
DTMF Reset Code
Reset By
Trigger by URI
Trigger Message
Rest Message
Trigger by SMS
Trigger SMS
Reset SMS
Trigger by Input
5 0
Enable or disable Output Response
Select the DTMF trigger ring tone.
Select the URI trigger ring tone.
Select the SMS trigger ring tone.
Select the Dsskey trigger ring tone.
When choosing the low level trigger (NO: normally open), when meet
the trigger condition, trigger the NO port disconnected.
When choosing the high level trigger (NC: normally close), when meet
the trigger condition, trigger the NC port close.
Set the output change duration time, the default is 5 seconds.
Enable or disable trigger by DTMF. The device will check the received
DTMF sent by remote device, if it matches the DTMF trigger code, the
device will trigger corresponding output port.
Input the DTMF trigger code, default value is 1234.
Input the DTMF reset code, default value is 4321.
Reset the output port mode by duration or state.
By duration: Reset the output port status when output duration occurs.
By state: Reset the output port status when device's call state
changes.
Enable or disable trigger by URI.
User can send commands from remote device or server to i10 series
device, if the command is correct, then device will trigger
corresponding output port.
Input trigger message for trigger by URI mode.
Input reset message for trigger by URI mode.
Enable or disable trigger by SMS.
User can send ALERT command to i10 series device, if the command
is correct, then device will trigger corresponding output port.
Input trigger message for trigger by SMS mode.
Input reset message for trigger by SMS mode.
Select the input port, when the input port meets the trigger condition,
the output port will be triggered (The Port level time change, By <
Output Duration > control)