Fanvil i10 User Manual page 41

Auto Onhook Time
Enable Silent Mode
Disable Mute for Ring
Ban Outgoing
Enable Restricted Incoming
List
Enable Restricted Outgoing
List
Enable Country Code
Country Code
Area Code
Allow IP Call
P2P IP Prefix
Restrict Active URI Source IP
Push XML Server
Line Display Format
Call Number Filter
Auto Resume Current
Tone Settings
Enable Holding Tone
Enable Call Waiting Tone
Play Dialing DTMF Tone
Play Talking DTMF Tone
Intercom Settings
Enable Intercom
Enable Intercom Mute
Enable Intercom Tone
Specify Auto Onhook time, the device will hang up and return to
the idle automatically after Auto onhook time.
When enabled, the device is muted, there is no ringing when calls,
you can use the volume keys and mute key to unmute.
Disable the mute mode, if this option is clicked, mute button on
device does not take effect.
Enable or disable ban outgoing, if enable, the device can not dial
out any number.
Whether to enable restricted incoming call list.
Whether to enable the restricted outgoing list.
Whether to enable the country code.
Fill in the country code.
Fill in the area code.
If enabled, user can dial out with IP address.
Set prefix for point-to-point IP calls.
Set the device to accept Active URI command from specific IP
address. Notice: this function is usually used to manage device.
Configure the Push XML Server, when phone receives request, it
will determine whether to display corresponding content on the
phone which sent by the specified server.
Custom line format SIPn or SIPn:xxx or xxx@SIPn
Configure a special ampersand, the called number is 78-9, the
ampersand will be filtered when device sends the call out.
Automatically break HOLD if current call changes.
Whether to enable call holding tone.
Whether to enable call waiting tone.
Play DTMF tone on the device when user presses a digits wehen
dial the call, by default it is enabled.
Play DTMF tone on the device when user presses a phone digits
during taking, by default it is enabled.
When intercom is enabled, the device will accept the incoming call
which requests with a SIP header of Alert-Info automatically.
Enable mute mode during the intercom call.
If the incoming call is intercom call, the device plays the intercom
3 5