Table of Contents
Advertisement
10
www.aeg.com
5.4 Setting the water hardness
The table below shows the water
hardness range (dH) with the
Water hardness
Class
1
2
3
4
When the water hardness exceeds the
values in the table, fill the water drawer
with bottled water.
1. Take the 4 colour change strip
supplied with the steam set in the
oven.
2. Put all the reaction zones of the strip
into the water for approximately 1
second.
Do not put the strip into the running
water.
3. Shake the strip to remove the excess
of the water.
4. Wait 1 minute and check the water
hardness with the table below.
The colours of the reaction zones
continue to change. Do not check
the water hardness later than 1
minute after test.
6. QUICK GUIDE
6.1 Using the touchscreen
• To scroll the menu use a quick
gesture or drag your finger across the
display.
• The strength of the gesture
determines how fast the screen
moves.
• The scroll movement can stop by
itself or you can stop it immediately if
you touch the display.
• The chosen function turns on when
you release the finger from the
display.
Calcium deposit
(mmol/l)
dH
0 - 7
0 - 1.3
7 - 14
1.3 - 2.5
14 - 21
2.5 - 3.8
over 21
over 3.8
corresponding Calcium deposit and the
quality of the water.
Calcium deposit
(mg/l)
0 - 50
50 - 100
100 - 150
over 150
5. Set the water hardness: menu: Basic
Settings.
Test strip
You can change the water hardness in
the menu: Basic Settings / Water
hardness.
• To turn on a menu function touch the
display on the selected function.
• You can change any parameter shown
on the display when you touch it.
• To set the required function, time or
temperature you can scroll through
the list or touch the option you want
to choose.
• When you turn on a heating function
the Menu does not appear on the
display. Touch the display anywhere
and the Menu appears again.
• When the oven is turned on, and
some of the symbols disappear from
the display, touch the display
Water classi-
fication
Soft
Moderately
hard
Hard
Very hard
Water hardness
1
2
3
4
Advertisement
Table of Contents
