Troubleshooting - AEG BSE896220B User Manual

The side lamp
1. Remove the left shelf support to get
access to the lamp.
2. Use a Torx 20 screwdriver to remove
the cover.
3. Remove and clean the metal frame
and the seal.

13. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
13.1 What to do if...
Problem
You cannot activate or oper-
ate the oven.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The display shows error mes-
sage "F....."
Steam and condensation
settle on the food and in the
cavity of the oven.
The appliance does not re-
tain the water drawer after
you insert it.
Water comes out of the wa-
ter drawer after you carry it
or put it inside the appli-
ance.
4. Replace the lamp with a suitable 300
°C heat-resistant lamp.
5. Install the metal frame and the seal.
Tighten the screws.
6. Install the left shelf support.
Possible cause
The oven is not connected
to an electrical supply or it is
connected incorrectly.
The oven is deactivated.
The necessary settings are
not set.
The Child Lock is on.
The fuse is blown.
The lamp is defective.
Electronic error.
You left the dish in the oven
for too long.
You did not assemble the lid
of the water drawer correct-
ly.
You did not assemble the lid
of the water drawer correct-
ly.
ENGLISH
Remedy
Check if the oven is correctly
connected to the electrical
supply (refer to the connec-
tion diagram if available).
Activate the oven.
Make sure that the settings
are correct.
Refer to "Using the Child
Lock".
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
Replace the lamp.
Contact an Authorised Serv-
ice Centre.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Assemble the lid of the wa-
ter drawer correctly.
Assemble the lid of the wa-
ter drawer correctly.
59