Table of Contents
Advertisement
– Remove the lid with a flat screwdriver, placing it in notch
⇒ page 228, fig.
156.
Changing bulbs
– Remove the bulb holder by pressing the fastening clips
⇒ fig. 157
and pulling outwards.
– Replace the faulty bulb, rotating it to the left and outwards.
– To refit follow the steps in reverse order, taking special care when
fitting the bulb holder.
Safety First
A
Fig. 157 Removing the
bulb holder
A
B
Operating Instructions
Side turn signals
A
– Press the turn signal to the left or to the right to remove the bulb.
– Remove the bulb holder from the turn signal.
– Remove the failed bulb and replace with a new bulb.
– Insert the bulb holder in the turn signal guide until it clicks into
place.
– First fit the turn signal in the opening in the chassis, fastening the
A
⇒ fig.
tabs
158, and then fit in the bulb as shown by the
1
A
⇒ fig.
arrow
158.
2
Practical Tips
If and when
Fig. 158 Side turn
signals
Technical Specifications
229
Advertisement
Table of Contents
