Table of Contents
Advertisement
60
Cockpit
Item
Symbol
A
If it stays lit: TCS disabled
23
Turn signals in operation
SAFE
Electronic immobiliser
WARNING
•
Failure to observe warning lamps and warning messages can result in
serious personal injuries or damage to your vehicle.
•
The risk of an accident increases if your vehicle breaks down. Use a
warning triangle to draw the attention of other road users in order to
prevent danger to third parties.
•
The engine compartment is a dangerous area! Before you open the
bonnet to work on the engine or in the engine compartment, you must
switch the engine off and allow it to cool to reduce the risk of scalding or
other injuries. Read and observe the relevant warnings ⇒ page 188.
Note
•
The appropriate warning lamp for a fault will light up in vehicles without
warning or information messages in the display.
•
In vehicles with warning or information texts on the screen, the appro-
priate warning lamp for a fault will light up and a warning or information
message will also appear on the screen.
Meaning of indicator and
warning lamps
information
⇒ page 64
⇒ page 64
⇒ page 68
⇒ page 68
⇒ page 74
Warning symbols
Further
There are red warning symbols (priority 1) and yellow warning
symbols (priority 2)
Warning reports, Priority 1 (red)
If one of these faults occurs, the warning lamp will flash or light up and will
be accompanied by three audible warnings. This is a danger warning. Stop
the vehicle and switch off the engine. Check the fault and correct it. Obtain
professional assistance if necessary.
If several priority 1 faults are detected at the same time, the symbols will be
displayed one after the other for about 2 seconds at a time and will continue
until the fault is corrected.
No menus will be shown in the display for the duration of a priority 1 warning
message.
Examples of priority 1 warning messages (red)
•
Brake system symbol
SERVICE MANUAL or STOP BRAKE FAULT SERVICE MANUAL.
•
Coolant symbol
INSTRUCTION MANUAL.
•
Engine oil pressure symbol
OIL PRESSURE LOW! INSTRUCTION MANUAL.
Warning reports, Priority 2 (yellow)
If one of these faults occurs, the warning lamp lights up, and is accompanied
by one audible warning. Check the corresponding function as soon as
possible although the vehicle may be used without risk.
If several priority 2 warning messages are detected at the same time, the
symbols are displayed one after the other for about 2 seconds at a time. After
a set time, the information text will disappear and the symbol will be shown
as a reminder at the side of the display.
with the warning message STOP BRAKE FLUID
with the warning message STOP SEE COOLANT
with the warning message STOP ENGINE
Advertisement
Table of Contents
