Seat IBIZA ST Owner's Manual page 216

214 If and when
WARNING
Loosen the wheel bolts only about one turn before raising the vehicle with
the jack, otherwise there is a risk of accident.
Note
•
Do not use the hexagonal socket in the screwdriver handle to loosen or
tighten the wheel bolts.
•
If the wheel bolt is very tight, you may be able to loosen it by pushing
down the end of the spanner carefully with your foot. Hold on to the vehicle
for support and take care not to slip.
Raising the vehicle
In order to remove the wheel, the vehicle must be raised with
a jack.
– Locate the jacking point under the door sill closest to the wheel
to be changed
– Place the jack under the jacking point and turn the crank until the
arm of the jack is directly below the vertical rib under the door
sill.
– Align the jack so that the arm of the jack fits around the rib under
the door sill and the movable base plate of the jack is flat on the
ground
– Raise the jack until the defective wheel is just clear of the ground.
Recesses at the front and rear of the door sills mark the jacking points
⇒ fig.
anywhere else.
An unstable surface under the jack may cause the vehicle to slip off the jack.
Fig. 137 Jack position
points Therefore, the jack must be fitted on solid ground offering good support. Use
⇒ fig.
137.
⇒ fig.
138.
137. There is only one jacking point for each wheel. Do not fit the jack
Fig. 138 Fitting the jack