Seat IBIZA ST Owner's Manual page 215

Wheel covers*
The wheel covers must be removed for access to the wheel
bolts
Removing
– Remove the wheel cover using the wire hook
– Hook this into one of the cut-outs of the wheel cover.
Fitting
– Fit the wheel cover onto the wheel rim by pressing it firmly. Put
pressure initially on the point of the cut-out for the valve. Next fit
the rest of the hubcap
Safety First
Fig. 135 Remove the
complete hub cap
⇒ fig.
135.
Operating Instructions
Loosening the wheel bolts
The wheel bolts must be loosened before raising the vehicle.
Loosening
– Fit the box spanner as far as it will go over the wheel bolt.
– Grasp the box spanner by the end turn it about one full turn to the
⇒ fig.
left 136.
Tightening
– Fit the box spanner as far as it will go over the wheel bolt.
– Grasp the box spanner close to the end and turn the bolt to the
right until it is secured.
– An adapter is required to unscrew or tighten the anti-theft wheel
bolts.
Practical Tips
If and when
Fig. 136 Changing the
wheel: loosen the wheel
bolts
Technical Specifications
213