Star Dot Impact Printer Specifications page 79

ESC # N m n1 n2 n3 n4 LF NUL
[Name] Set memory switch
[Code] ASCII
Hexadecimal
Decimal
[Defined Area] m = 44, 43, 45 (m = ",", "+", "-")
48 ≤ N ≤ 57 ("0" ≤ N ≤ "9"), 65 ≤ N ≤ 70 ("A" ≤ N ≤ "F")
48 ≤ n1 ≤ 57 ("0" ≤ n1 ≤ "9"), 65 ≤ n1 ≤ 70 ("A" ≤ n1 ≤ "F")
48 ≤ n2 ≤ 57 ("0" ≤ n2 ≤ "9"), 65 ≤ n2 ≤ 70 ("A" ≤ n2 ≤ "F")
48 ≤ n3 ≤ 57 ("0" ≤ n3 ≤ "9"), 65 ≤ n3 ≤ 70 ("A" ≤ n3 ≤ "F")
48 ≤ n4 ≤ 57 ("0" ≤ n4 ≤ "9"), 65 ≤ n4 ≤ 70 ("A" ≤ n4 ≤ "F")
[Initial Value] ---
[Function] Sends command to write after defining memory switch using the definition command specified by the
following classes.
This command is set only and not changed for the current operating environment.
Changed settings are valid after the power is turned on again, or when the printer is reset.
Consider the life of the non-volatile memory and avoid over-sue of this command.
Function
Data Definition (Data Specification)
Data definition (set specified bit)
Data definition (clear specified bit)
• m:
• N:
• n1 n2 n3 n4:
Note The status of this command varies according to the model, so check the special appendix.
STAR Command Specifications
ESC # N m n1
1B 23 N m n1
27 35 N m n1
Class
Definition
Definition
Definition
Mode Selection
Memory switch number to specify
Setting Data m = "," → Specified data
m = "+" → Bit number to set
m = "-" → Bit number to clear
n2 n3 n4 LF NUL
n2 n3 n4 0A 00
n2 n3 n4 10 0
m N
"," N
"+" N
"-" N
3-71
n1 n2 n3 n4
n1 n2 n3 n4
n1 n2 n3 n4
n1 n2 n3 n4
Rev. 0.70