Star Dot Impact Printer Specifications page 68

ESC s n1 n2
[Name] Set two byte Kanji characters left/right spaces
[Code] ASCII
Hexadecimal
Decimal
[Defined Area] 0 ≤ n1 ≤ 255
0 ≤ n2 ≤ 255
(However, n1 + n2 + character width ≤ printable region)
[Initial Value]
• Japanese specifications
Memory SW n1
Condition (1) 0
Condition (2) 0
• For China and Taiwan specifications
Spec. 1: n = 0, n2 = 4
Spec. 2:
Memory SW n1
Condition (1) 0
Condition (2) 0
[Function] n1, n2 specified spaces are Japanese character spaces. n1 is the left side character; n2 is the right side
character.
The values of n1 and n2 when using two-byte 8 x 16, two-byte 16 x 16 and double-tall 8 x 16 characters
correspond to 1/2 dots; the n1 and n2 values when using double high and wide 16 x 16 characters
correspond to 1 dot.
If the Japanese character size including the right and left spaces (n1 + character width + n2) exceeds the
print region, printing will not be possible and a question mark ("?") will be printed instead.
This command is ignored for models not equipped with Chinese fonts (for overseas) and when the
specification for the location of use is specified as SBCS (single byte countries) by the memory switch.See
each printer's product specifications manual for details on the memory switch settings.
ESC t n1 n2
[Name] Set 1 byte Kanji characters left/right spaces (Japanese specifications only)
[Code] ASCII
Hexadecimal
Decimal
[Defined Area] 0 ≤ n1 ≤ 255
0 ≤ n2 ≤ 255
(However, n1 + n2 + character width ≤ printable region)
[Initial Value] Memory switch setting
Memory SW n1
Condition (1) 0
Condition (2) 0
[Function] n1, n2 specified spaces are Japanese character spaces.n1 is the left side character; n2 is the right side
character.
The values of n1 and n2 when using two-byte 8 x 16, two-byte 16 x 16 and double-tall 8 x 16 characters
correspond to 1/2 dots; the n1 and n2 values when using double high and wide 16 x 16 characters
correspond to 1 dot.
If the Japanese character size including the right and left spaces (n1 + character width + n2) exceeds the
print region, printing will not be possible and a question mark ("?") will be printed instead.
This command is ignored for models not equipped with Japanese characters and when the specification for
the location of use is specified as SBCS (single byte countries) by the memory switch.See each printer's
product specifications manual for details on the memory switch settings.
STAR Command Specifications
ESC s n1 n2
1B 73 n1 n2
27 115 n1 n2
Memory switch setting
n2
2
4
Memory switch setting
n2
4
2
ESC t n1 n2
1B 74 n1 n2
27 116 n1 n2
n2
1
2
3-60
Rev. 0.70