Table of Contents
Advertisement
BEFORE EMBROIDERING
BEFORE EMBROIDERING
Embroidery Step by Step
Follow the steps below to prepare the machine for
embroidery.
Step 1, 2
Step 3
Step 7
Step #
Aim
1
Presser foot
attachment
2
Checking the
needle
3
Embroidery unit
attachment
4
Bobbin thread
setup
5
Fabric preparation Attach a stabilizer material to
6
Pattern selection
7
Embroidery frame
attachment
8
Checking the
layout
9
Embroidery upper
thread setup
106
Step 9
Step 6, 8
Step 4
Step 5
Action
Attach embroidery foot "W+"
with LED pointer.
Use needle 75/11 for
embroidery.
Attach the embroidery unit.
For the bobbin thread, wind
embroidery bobbin thread and
set it in place.
the fabric, and hoop it in the
embroidery frame.
Turn the main power to ON,
and select an embroidery
pattern.
Attach the embroidery frame
to the embroidery unit.
Check and adjust the size and
position of the embroidery.
Set up embroidery upper
thread according to the
pattern.
Attaching Embroidery Foot "W+" with LED
Pointer
• When attaching an embroidery foot, always
press
accidentally press the "Start/Stop" button and
possibly cause injury.
• Be sure to use embroidery foot "W+" with LED
pointer when doing embroidery. Using
another embroidery foot may cause the needle
to strike the embroidery foot, causing the
needle to bend or break and possibly cause
injury.
a
Remove the presser foot and presser foot holder.
(page 50)
b
Position the embroidery foot "W+" with LED pointer
on the presser foot bar by aligning the notch of the
presser foot to the large screw.
Side view
Page
106
48
107
36
c
Hold the embroidery foot in place with your right
hand, and then use the disc-shaped screwdriver to
securely tighten the presser foot holder screw.
127
108
130
131
1 Presser foot holder screw
42
• Use the disc-shaped screwdriver to firmly
tighten the presser foot holder screw. If the
screw is loose, the needle may strike the
embroidery foot and possibly cause injury.
CAUTION
on the screen. You may
a
CAUTION
Advertisement
Table of Contents
