Table of Contents
Advertisement
ERROR MESSAGES
OK to cancel the current stitch selection?
19
20
OK to delete the selected picture?
OK to delete the setting?
21
OK to move the embroidery carriage to its previous
22
position?
OK to recall and resume previous memory?
23
OK to revert to previous color changes?
24
OK to separate the combined border pattern?
25
Pattern extends to the outside of embroidery frame.
26
Pattern extends to the outside of embroidery frame.
27
If you plan to add more patterns, rotate the pattern
combination.
Preventive maintenance is recommended.
28
Raise the buttonhole lever.
29
Remove Dual Feed module from the machine.
30
Remove Embroidery foot with LED pointer from the
machine.
31
Select a pattern.
32
Select a stitch.
33
Set the clock.
34
The "Start/Stop" button does not operate with the
35
foot controller attached. Remove the foot controller.
188
Error messages
Cause/solution
This message is displayed when, after selecting a stitch pattern,
,
, or
about to be deleted.
This message is displayed when the image is deleted.
This message appears when
settings for a utility stitch. To delete the selected settings, press
This message is displayed when replacing the embroidering bobbin thread.
This message appears if the machine is turned off while embroidering, then
turned on again. Press
to return the machine to the condition (pattern
position and number of stitches) when it was turned off. Follow the
procedure described in "If the Thread Breaks or the Bobbin Runs out of
Thread During Embroidering" on page 138 to align the needle position and
embroider the remainder of the pattern.
This message is displayed when
colors.
This message is displayed when rotating a saved combined pattern in the
embroidery screen.
This message is displayed when the machine is in embroidery mode, and the
character pattern combination is too large to fit in the embroidery frame.
This message is displayed when the machine is in embroidery mode and the
combined character pattern is too large for the embroidery frame. You can
rotate the pattern 90 degrees and continue combining characters.
This message is displayed when the machine needs to be maintained.
Once this message appears, it is recommended to take your machine to an
authorized Brother dealer or the nearest Brother authorized service center for
a regular maintenance check. Although this message will disappear and the
machine will continue to function once you press
display several more times until the appropriate maintenance is performed.
This message is displayed when the buttonhole lever is down, a stitch other
than a buttonhole is selected, and the "Start/ Stop" button,
stitch button) or
(reinforcement stitch button) is pushed.
This message appears when you try to start embroidering with the dual feed
foot attached to the machine. Remove the dual feed foot before entering the
embroidery mode.
This message appears when you try to start sewing utility stitches or
character/decorative stitches with the embroidery foot with the LED pointer
attached to the machine.
Remove the embroidery foot with the LED pointer before entering the sewing
mode.
This message is displayed when there is no embroidery pattern selected and
the "Start/Stop" button,
(reverse stitch button) or
stitch button) is pressed.
This message is displayed when there is no stitch pattern selected and the
"Start/Stop" button,
(reverse stitch button) or
button) is pressed.
This message appears when the time/date is not set. Set time/date.
(page 22)
This message is displayed when the "Start/Stop" button is pushed to sew
Utility stitches or Character/Decorative stitches while the foot controller is
connected. (This message does not appear when embroidering).
is pressed and the stitch pattern is
or
is pressed to delete the
is pressed when changing thread
, the message will
(reverse
(reinforcement
(reinforcement stitch
.
Advertisement
Table of Contents
