Table of Contents
Advertisement
Using the Machine Settings Key
Press
to change the default machine settings
(needle stop position, embroidery speed, opening
display, etc.). To display the different settings screens,
press
for "Sewing settings",
settings",
for "Embroidery settings" or
"Wireless LAN settings".
Memo
• Press
or
to display a different settings
screen.
■ Sewing Settings
1 Select whether to use the sewing speed controller to
2 Make adjustments to character or decorative stitch
3 Adjust the presser foot height. Select the height of the
4 Adjust the presser foot pressure. The higher the number,
for "General
5 Adjust the amount of fabric feeding of the dual feed foot
for
6 Select whether [1-01 Straight stitch (Left)] or [1-03
7 Select whether utility stitches
8 You can activate this setting after connecting the multi-
1
2
3
4
5
9 Select the height of the presser foot when sewing is
0 Select the height of the presser foot when the machine is
A When set to [ON], the thickness of the fabric is
6
B When set to [ON], reinforcement stitches are sewn at the
7
C Adjust the guideline marker position and brightness
8
D Select whether to lower the presser foot automatically
E Select whether to raise the presser foot automatically
F Select whether pressing
G
G You can save the current settings screen image in a USB
H
9
H Reset settings on this page to original default. Some
0
A
B
C
D
E
F
determine the zigzag width (page 79).
patterns (page 97).
presser foot when the presser foot is raised.
the greater the pressure will be. Set the pressure at [3]
for normal sewing.
(page 53).
Straight stitch (Middle)] is the utility stitch that is
automatically selected when the machine is turned on.
are displayed first on the stitch selection screen.
function foot controller (sold separately). (These settings
appear when the multi-function foot controller is
connected to the machine.)
Controller
Functions that can be specified
Main foot controller
Start/Stop
Heel switch
Select any of the following:
• [Thread Cutting]
• [Needle Position Up/Down]
Side pedal
• [Single Stitch]
• [Reverse Stitch] (Reinforcement
Stitch)
• [Presser Foot Up/Down]
• [No setting]
stopped when the pivot setting is selected (page 65).
set to free motion sewing mode (page 80).
automatically detected by an internal sensor while
sewing. (page 67)
beginning and/or end of sewing for a reinforcement
stitch pattern, even when
(Reverse stitch button) is
pressed (page 60).
(page 65).
before starting sewing. (page 61)
when stopping sewing. (page 61)
(Thread cutter button)
automatically lowers the presser foot before cutting the
thread. The presser foot will be raised after the thread is
cut. (page 61)
media by pressing this button when the USB media is
inserted into the USB port. The files are saved in a folder
labeled [bPocket].
settings are not reset.
LCD SCREEN
1
or quilting stitches
27
Advertisement
Table of Contents
