Table of Contents
Advertisement
g
Reattach the bobbin cover.
Insert the tab of the bobbin cover into the notch of the
needle plate cover, and then lightly press down on the
right side.
Memo
• You can begin sewing without pulling up the
bobbin thread. If you wish to pull up the bobbin
thread before starting to sew, pull up the thread
according to the procedure in "Pulling Up the
Bobbin Thread" on page 41.
h
Press
to unlock all keys and buttons.
Pulling Up the Bobbin Thread
There may be some sewing applications where you
want to pull up the bobbin thread; for example, when
making gathers, darts, or doing free motion quilting or
embroidery.
Memo
• You can pull up the bobbin thread after threading
the upper thread ("UPPER THREADING" on
page 42).
a
a
c
Follow steps
to
page 40 for installing the bobbin into the bobbin case.
b
Guide the bobbin thread through the groove, following
the arrow in the illustration.
*
Do not cut the thread with the cutter.
*
Do not replace the bobbin cover.
c
Press
to unlock all keys and buttons.
d
While lightly holding the upper thread with your left
hand, press
(Needle position button) twice to
lower and then raise the needle.
in "Setting the Bobbin" on
WINDING/INSTALLING THE BOBBIN
e
Gently pull the upper thread. A loop of the bobbin
thread will come out of the hole in the needle plate.
f
Pull up the bobbin thread, pass it under the presser
foot and pull it about 10 cm (4 inches) toward the back
of the machine, making it even with the upper thread.
g
Reattach the bobbin cover.
1
41
Advertisement
Table of Contents
