Camera Alignment; Fine Tune; Figure 82: Emergency Tape Break Switch; Figure 83: Rj45 Connection - Smartrise C4 User Manual

C4 User Manual

Figure 82: Emergency Tape Break Switch

7.8 Camera Alignment

The camera assembly must be aligned.

7.9 Fine Tune

After the camera is in place, the position must be verified.
Power the APS camera via a RJ45 cable to the CT SRU board so a red array can be seen on the
tape to allow for alignment. If there is no red array on the tape, reset the power by
disconnecting and reconnecting the RJ45 cable to the SRU board CAT5 connector.

Figure 83: RJ45 Connection

Page 94 © 2019 Smartrise Engineering, Inc. All Rights Reserved August 15, 2019