Terminal Speed Reducing Device (Tsrd) Test; Camera Independence Test - Smartrise C4-H Installation And Testing Procedure

..C4-H Testing Procedures..
- In the up direction – NTS Up P1-1, NTS Up P1-2, NTS Up P1-3, NTS Up P1-4, NTS Up P1-5,
NTS Up P1-6, NTS Up P1-7, NTS Up P1-8.
- In the down direction – NTS Dn P1-1, NTS Dn P1-2, NTS Dn P1-3, NTS Dn P1-4, NTS Dn P1-5,
NTS Dn P1-6, NTS Dn P1-7, NTS Dn P1-8.
NOTE: The alarm may only be viewed in Alarms Logged. Navigate to ALARMS | LOGGED.
9. The car will come to a stop prior to the final limit and then do a correction run to the floor.
10. Remove jumper from M24 to the MM input on MR board.
11. Recycle the MR board to clear the fault.

2.2 Terminal Speed Reducing Device (TSRD) Test

Applicable Code – ASME A17.1/B44-19 section 3.25.2
If the car is not at a terminal floor the car will first travel to the bottom floor prior to running test.
The following procedure describes how to test the TSRD.
1. Install a temporary jumper from M24 to the MM input on the MR board.
2. Toggle the NORMAL/INSPECTION and switch to NORMAL.
3. Navigate to MAIN MENU | DEBUG |ENTER CAR CALLS.
4. Enter a car call to the bottom landing.
5. Navigate to MAIN MENU | DEBUG | ACCEPTANCE TEST.
6. Scroll and select HYDRO TSRD and save.
7. Verify the display shows Prepare for Test then Parameter Setup.
8. Press the Enable and Up buttons.
NOTE: After the car starts, it runs at high speed and gets close to the top landing. The car faults
out with TSRD OVERSPEED fault.
9. Remove jumper from M24 to the MM input on MR board.
10. Recycle the MR board to clear the fault.

2.2.1 Camera Independence Test

Applicable Code – ASME A17.1/B44-19 section 3.25.2
The following procedure explains the Camera Independence test.
1. Install a temporary jumper from M24 to the MM input on the MR board.
2. Toggle the NORMAL/INSPECTION and switch to NORMAL.
3. Navigate to MAIN MENU | DEBUG |ENTER CAR CALLS.
2023 © Smartrise Engineering, Inc. All Rights Reserved
2