Figure 93: Tape Clip Insertion; Figure 94: Tape Clip Assembly Alignment - Smartrise HYDRO:EVOLVED User Manual

Hydro:Evolved User Manual
Holding the Tape Clip Assembly with one hand and the tape with the other, rotate the
tape into the tape clip.
CAUTION: Do not twist or bend the tape as this may damage the tape.

Figure 93: Tape Clip Insertion

Place the Tape Clip Assembly onto the guide rail with the edge flush to the rail.
CAUTION: There are strong magnets. Do not remove the bracket from the rail by pulling
the bracket from the far end as this may bend the bracket.

Figure 94: Tape Clip Assembly Alignment

October 2022 © 2022 Smartrise Engineering, Inc. All Rights Reserved Page 85