C4 User Manual
CAUTION: Do not twist or bend the tape as this may damage the tape.
4. Place the Tape Clip Assembly onto the guide rail with the edge flush to the rail.
CAUTION: There are strong magnets. Do not remove the bracket from the rail by pulling
the bracket from the far end as this may bend the bracket.
5. Verify that the DZ blade is vertically centered with the GLS Reader optical axis.
Page 124
Figure 168: Tape Clip Insertion
Figure 169: Tape Clip Assembly Alignment
Figure 170: Optical Axis
©2021 Smartrise Engineering, Inc. All Rights Reserved
October 25, 2021