INSTALLATION
2.4.2.1 Power Supply Input Connection
85 to 265 V AC
The AC power supply connection is a push fi t socket labelled
below.
The method of connection is as follows:
a.
Turn off the AC power. Ensure that both ends of the power cable are
potential free, i.e. not connected to an AC power supply.
b.
Check that the
c.
Push the IEC connector fi rmly into the
d.
Connect the free end of the power cable to a suitable AC power supply
source (voltage range 85 to 265 V AC, 47/63 Hz) and switch on the
AC supply. The instrument may then be switched on, as required, by
pressing the
18
POWER INPUT Socket
Figure 10
switch is switched to
ON/OFF
switch.
ON
Liquidew I.S. User's Manual
POWER INPUT
POWER INPUT
Socket
IEC connector
.
OFF
socket.
POWER INPUT
97092 Issue 5.1, October 2018
as shown
Need help?
Do you have a question about the Liquidew I.S. and is the answer not in the manual?