User-Defi Ned Liquid - Michell Instruments Liquidew I.S. User Manual

Liquidew I.S. User's Manual
3.5.2 User-Defi ned Liquid
If the process liquid is not listed the user can defi ne their own liquid solubility profi le
by entering the
to +140°F)) for that particular liquid. There are two user-defi ned liquids available and
these are named USER 1 and USER 2.
a. In the liquid list in the 'LIQUID SETUP' sub menu, use the  and  keys
to scroll to:
User-defi ned liquids are found near to the end of the list.
b. Press the
profi le of this liquid. The fi rst temperature point for the
c. Use the  and  keys to adjust the
d. Press the
temperature point, -10°C.
e. Follow steps c. and d. to enter the
point, and then repeat for 20°C, 30°C, 40°C, 50°C, 60°C. If
not available for temperature points outside of expected measurement
conditions then enter an estimated value (extrapolated by drawing a
curve in such cases).
f. After entering the
Select
Page, and calculations will then based on the USER 1 solubility profi le.
For the second user-defi ned liquid USER 2, the solubility profi le can be
entered in USER 2, following the above procedure:
Michell Instruments
C
value (10 pre-set temperature points, over the range 0 to +60°C (32
S
key to access the
Select
? ? ?
0 C
key to confi rm. The display will then display the next
Select
? ? ?
1 0 C
C
value for the 60°C temperature point, press the
S
key to confi rm. The display will then return to the Main Reading
U S E R 1
U S E R
C
value table and defi ne the solubility
S
C
value
S
Temp point °C
C
value.
S
C
value
S
Temp point °C
C
value for the 10°C temperature
S
U S E R 2
U S E R
OPERATION
1
C
value is at 0°C.
S
C
values are
S
2
35