Main Reading Page; Liquid Set-Up; Liquid Selection; Table 1 Liquid List - Michell Instruments Liquidew I.S. User Manual

OPERATION
3.4

Main Reading Page

The Main Reading Page is the default screen shown after turning the instrument on. It
will display the units of measurement selected by the user (see Section 3.2.2).
3.5

Liquid Set-Up

The saturation concentration
calculation from the measured water dew point (°C/°F), and the sample temperature
(°C/°F), to the moisture content (ppm
is a list of liquids with pre-set
pre-programmed, plus two selections for user-confi gured
one possibility to set a mixing ratio of two of the 8 pre-set and two confi gurable solutes.
3.5.1

Liquid Selection

From the Main Reading Page, press the
setting option is:
Press the
Select
currently selected liquid. The factory default setting is Butane. The full name of the
liquid will scroll across the bottom line of the display.
a. Change the selection by scrolling through the liquid list using the  and
 keys.
b. When the desired liquid is shown on the display, press the
confi rm. The display will then return to the Main Reading Page and the
calculations will then be based on the selected liquid.
NOTE: The next time the 'LIQUID SETUP' sub menu is entered it will go directly
to the currently selected liquid.
34
C
values of the sample liquid need to be specifi ed for
S
) using Henry's Law. With the Liquidew I.S. there
W
C
values for calculation. Solubility data for 8 solutes are
S
Liquid Name
Butane
Propane
Hexane
Benzene
Toluene
Propylene
Isobutane
Butadiene 1,3
User 1
User 2
Mixing
Table 1
L I Q U I D
S E T U P
key to enter this sub menu. The display will show the name of the
N - B U T A
N - B U T A N E
Liquidew I.S. User's Manual
C
values to be entered, and
S
Displayed Name
N-BUTANE
N-PROPANE
N-HEXANE
BENZENE
TOLUENE
PROP-1-ENE
I-BUTANE
BUTADIENE-1-3
USER 1
USER 2
MIXING
Liquid List
key to enter the main menu. The fi rst
Menu
97092 Issue 5.1, October 2018
key to
Select