Installing The Protective Cover - Siemens FDM223 Technical Manual

5.4 Installing the protective cover

007002_k_en_--
If a protective cover (accessories) is used, proceed as follows:
w
A compatible protective cover is available. See the chapter
'Accessories [➙ 22]'.
1. Open the door of the manual call point.
2. Remove the glass insert. See the chapter 'Replacing the glass insert [➙ 45]'.
3. Guide the protective cover (1) through the opening in the door from the front,
as shown in the diagram.
4. Insert the pivot pins (2) for the protective cover (1) in the two recesses on the
rear side of the door, as shown in the diagram.
5. Install the glass insert. See the chapter 'Replacing the glass insert [➙ 45]'.
6. Close the door of the manual call point.
a The protective cover is inserted.
Figure 17: Example of installing protective cover DMZ1197-AC on a manual call point
1 Protective cover DMZ1197-AC
See also
2 Protective cover DMZ1197-AC [➙ 23]
2
Installation [➙ 31]
Installing the protective cover
2
1
2 Pivot pin
Mounting / Installation
35 | 54
5