Outputs; Output Types; Digital (Dout) - Danfoss PLUS+1 SC0XX-1 Series Technical Information

Technical Information
PLUS+1 SC0XX-1XX Controller Family

Outputs

Output types

Output pins available on SC Controller Family
SC Controller
SC024-110/112
SC024-120/122
SC050-120/122
SC050-13H

Digital (DOUT)

General
Description
Configuration
Type
Short circuit to ground protection
Open circuit detection
Parallel operation
Shut off
12 | © Danfoss | June 2016
•
Digital (DOUT)
•
Pulse Width Modulated (PWM/DOUT/PVGOUT)
DOUT (3 A)
6
6
The power pin of a PVG valve should only be connected to a digital output.
PLUS+1 ® control modules feature user-configurable output pin parameters. Output pin parameters
are configured using PLUS+1
Refer to module data sheets for maximum output current ratings of individual modules. The total
output current for any PLUS+1
the module data sheet.
W
Warning
Unintended movement of the machine or mechanism may cause injury to the technician or
bystanders. The module will be powered up if battery voltage is applied to the module's output pin.
To protect against unintended movement, secure the machine.
C
Caution
Warranty will be voided if module is damaged by significant current driven back through an output
pin.
Digital outputs can source up to 3 A.
Comment
Sourcing only.
Linear switching.
Non-damage, current/thermal limit with status indication; automatic latch off /resume.
Fault indication provided. The GUIDE Pin Status requires a load of 0.22 A to be
connected or an open fault will be declared.
Digital outputs from the same module are capable of being connected together such
that the net current rating is the sum of the individual ratings; timing is resolved by the
operating system; diagnostic capability is maintained.
Processor control with hardware WatchDog override.
PWMOUT/DOUT/(3 A)
4
8
8
8
® GUIDE templates.
®
module must not exceed the maximum allowable current specified in
L1415500 | BC00000235en-US0201