Product Installation And Start-Up; General Comments; Mating Connectors; Product Installation - Danfoss PLUS+1 SC0XX-1 Series Technical Information

Technical Information
PLUS+1 SC0XX-1XX Controller Family

Product installation and start-up

General comments

®
Deutsch mating connector part information
Description
Crimp tool
Contacts
Connector plug
Wedge
Strip length
Rear seal maximum insulation OD
Sealing plugs
Danfoss mating connector part information
Description
Mating connector bag assembly (20 to 24 AWG)
Mating connector bag assembly (16 to 20 AWG)
Danfoss crimp extraction tool part information
Description
Crimp tool for 20 to 24 AWG
Crimp tool for 16 to 20 AWG
Extraction tool Deutsch 114010; 12 AWG
Extraction tool Deutsch 0144-240-2005; 16 to 20, 20 to 24 AWG

Product installation

22 | © Danfoss | June 2016

Mating connectors

The SC Controller Family use Deutsch
referred to as a bag assembly, for the 24 and 50 pin module housings. Mating connector bag assembly
ordering information is found in the product data sheet for each module.
24 pin module
HDT48-00 (solid contacts) (20 to 24 AWG)
DTT20-00 (stamped contacts) (16 to 20 AWG)
Solid: 0462-201-2031 (20 to 24 AWG)
Stamped: 1062-20-0144 (16 to 20 AWG)
Gray A-Key DTM 06-12SA Black B-Key DTM
06-12SB
WM-12S
3.96 to 5.54 mm [0.156 to 0.218 in]
3.05 mm [0.120 in]
0413-204-2005
PLUS+1 module mating connectors may be mated 10 times.
®
Recommended torque for the Deutsch
2.26 N•m (20 lb•in).

Mounting

PLUS+1 ® modules can be mounted in one of three ways:
•
End (bulkhead) installation
•
Up to 3 units stacked on one another
•
Individually side mounted
In each case, care must be taken to insure that the module connector is positioned so that moisture
drains away from the connector. If the module is side or stack mounted, provide a drip loop in the
® connectors. Danfoss has assembled a mating connector kit,
50 pin module
HDT48-00 (solid contacts) (20 to 24 AWG)
DTT20-00 (stamped contacts) (16 to 20 AWG)
Solid: 0462-201-2031 (20 to 24 AWG)
Stamped: 1062-20-0144 (16 to 20 AWG)
DRC26-50S01
Not required
3.96 to 5.54 mm [0.156 to 0.218 in]
2.41 mm [0.095 in]
0413-204-2005
24 pin module
10100945
10102023
Part number
10100745
10102028
11068808
10100744
mating connector retaining fastener on the 50 pin connector is
®
50 pin module
10100946
10102024
L1415500 | BC00000235en-US0201